LEXIBOOK K8250 Mode D'emploi page 20

Your Bluetooth® system remote control works with
1 x CR2025 3V
Replacing the battery:
1. To open the battery compartment, push the tab sideway
and pull the compartment downwards.
2. Install the 1 x CR2025 3V
3. Insert the compartment back in the remote control rear
panel.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries
are to be removed from the product before being charged. Rechargeable
batteries are only to be charged under adult supervision. Different types of
batteries or new and used batteries are not to be mixed. Only batteries of the
same or equivalent type as recommended are to be used. Batteries are to
be inserted with the correct polarity. Exhausted batteries are to be removed
from the product. The supply terminals are not to be short circuited. Do not
throw batteries into a fire. Remove the batteries if you are not going to use the
product for a long period of time. Battery shall not be exposed to excessive
heat such as sunshine, fire or the like.
WARNING: Malfunction or loss of memory may be caused by strong frequency
interference or electrostatic discharge. Should any abnormal function occur,
remove the batteries and insert them again.
WARNING: Risk of explosion if battery is incorrectly replaced. Please only replace
it with an equivalent or same battery.
Do not ingest the battery, Chemical Burn Hazard
The remote control supplied with this product contains a coin/button cell battery. If
the coin/button cell battery is swallowed, it can cause severe internal burns in just
2 hours and can lead to death. Keep new and used batteries away from children.
If the battery compartment does not close securely, stop using the product and
keep it away from children. If you think batteries might have been swallowed or
placed inside any part of the body, seek immediate medical attention.
K8250_02IM1288_101_V08.indb 20
BATTERIES INFORMATION FOR REMOTE CONTROL
type battery (included).
battery (included).
20
0
0
0
0
0
0
0
ON
OF F
10/7/18 3:05 pm