Publicité
Les langues disponibles
Les langues disponibles
Installation
To use the W810 radio buoy it is necessary to follow the steps below:
•
Proceed to the registration of the purchased buoy; this operation
is carried out by the dealer / distributor at Iridium or can be
requested directly to Wamblee via email (info@wamblee.it),
specifying the code of the buoy (1) reported on the engagement
tab.
EN
•
Make the installation of the fxing bracket W850 (8) on the vessel
in a free area of the boat, which does not make the passage
difcult. For the installation we suggest to use the 4 holes on the
rear side of the bracket.
•
Install the W840 module (battery charger) next to the fxing
brackets. A single W840 battery charger module can be used - not
at the same time - for several W810 radio buoys.
•
You can install the W855 counterweights using the appropriate
lockable plug. (11 & 12)
•
It is possible to install the antenna on the radio buoy by following
the steps indicated at points (2), (3) and (4), that is screw +
antenna + washer + wing nut. Tighten them well with your hand.
In case of limited space on board, it is possible to install the
antenna even shortly before launching the radio buoy into the
sea.
Your W810 radio buoy is ready to be used.
Use of the W810 radio buoy
To use the W810 radio buoy:
•
Make sure you have registered the W810 to Iridium SBD Service
using the IMEI code from Wamblee and performing the transfer of
ownership of the module.
Make sure that the battery has been properly charged, otherwise
•
proceed with a full charge (6 hours).
•
If there is not the antenna on the radio buoy, install the stylus by
following the steps indicated at points (2), (3) and (4), that is
screw + antenna + washer + wing nut. Tighten them well with
24
Publicité
