Single Use - Advanced-Star Large Space Humidification System Manuel Utilisateur

2 - Shown as chart 3.4, connect the
1/2'' & quot; to 1/4'' & quot; Push-fit into the water
inlet, joint the filter with 1/4'' & quot; on both
sides-one to the water inlet,
the other to the water supply, and have the filter fixed
into the mounting clip (Mark: filter is
optional part for hard water only)
3 - Shown as Chart 3.5, the pipe
connect to the water supply must
use 1/2'' & quot; to 1/4'' & quot; Push-fit connector
with PE shut off valve on it; outlet
connected by 1/2'' & quot; to 1/4'' & quot; Push-fit
connector.
Mark:
when use the push-fit kits, remove the plastic
semi-ring first and push the pipe till cannot push
forward anymore, then plug it back
4
APLLICATION
-
4.1

Single Use

1 - Shut off the outlet valve
2 - Open the inlet valve
3 - Open the nozzle cover
4 - AC 100-240v
5 - Power switch
6 - Humidity knob (20%-100%)
Mark:
1 - The humidifier will work in 10 seconds after refill water.
2 - For short time nonuse of the humidifier, shut off the power switch; for long time non-use, cutoff the power,
shut off water inlet valve, open the water outlet valve, cover the nozzle cover.
(2)
Connect the tap water
1/2'' à 1/2''
pushfit
connector
3/8'' PE
pipe
Filter
1/4'' pushfit connector
(1)
(6)
Connect the drainpipe
Chart 3.4
Chart 3.5
(3)
(5)
(4)
17
p