Device Information; Network Information - Hitachi ATW-MBS-02 Manuel D'installation Et De Fonctionnement

INSTALLATION

Configuration of device and communication

Device information

Check that the network device is correctly displayed at the Device information table. Press refresh button if necessary.

Network information

When the network device is integrated to the LAN / Modbus net by Ethernet, configure the following parameters:
• IP Address: Allow to modify the IP of the Network device port (192.168.0.4 by default).
• Mask: Ask to your IT technician for the proper value (255.255.255.0 by default).
• Gateway: LAN gateway address (192.168.0.1 by default).
Serial Information
When the network device is integrated to the Modbus net by serial port RS485, configure the following parameters:
• RS485: 9600 / 19200 Bps (19200 Bps by default)
• RS485: None / Odd / Even parity (Even by default)
• Modbus Id: 1~128 (1 by default)
• Polarization: Communication polarization (Disabled by default)
8 PMML0419A rev.1 - 05/2016