Blowing Operation; Maintenance - DURAVAC CVP205 Manuel D'utilisation

This Wet/Dry Vac has blowing capabilities. To use the blower feature follow the instructions listed.
WARNING:
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR IN CANADA,
CSAZ94.3) BEFORE USING BLOWER.
WARNING:
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WARNING:
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE INHALED.
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Make sure the container is empty before using as a blower.
3. Remove hose from the vacuum port.
4. Insert the larger end of the hose into the blowing port on the backside of the power head. (fig.2)
5. Ensure the power switch is turned off and plug into the power supply. (fig.3 & 4)
6. Before turning on the vac, firmly hold loose end of the hose. Turn the motor on by flipping the switch to
the 'I' ON position. (fig.5)
MAINTENANCE & FILTER CLEANING
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Disconnect the hose from the vacuum. (fig.2)
3. Undo the latches and remove the power head from the container. (fig.3 & 4)
4. Clear all dirt or debris from the container and hose. (fig.5)
For filter changing and maintenance see instructions on page 10.
IMPORTANT!
Clean or change the dust filter regularly for best performance. ALWAYS USE DUST
FILTER FOR DRY VACUUMING. If the machine is used with out the dust filter, the motor will burn out and
the warranty will be voided. Always keep spare filters on-hand.

BLOWING OPERATION

9