Installing & Cleaning Reusable Cloth Filter; Installing & Cleaning Foam Sleeve Filter - DURAVAC CVP205 Manuel D'utilisation

NOTICE!
The filter included is made of high quality material designed to stop small dust particles. The filter
should be used for dry pick-up only. A dry filter is necessary to pick up dust. If the dust filter is wet, it will
clog quickly and be very difficult to clean. Handle the filter carefully when removing it for cleaning and
replacing it. Check the filters for tears or small holes, a small hole can let dust pass through and out of the
cleaner. Do not use a filter with holes or tears, replace it immediately.
WARNING:
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET BEFORE REMOVING
THE POWER HEAD FROM CONTAINER.
INSTALLING & CLEANING REUSABLE CLOTH FILTER
Installing Reusable Cloth Filter
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Remove power head and place in upside down position.
3. Slide reusable cloth filter down over the filter cage making sure the whole cage is covered. (fig.2 & 3)
4. Replace and lock the power head on to the container.
Removing and Cleaning Reusable Cloth Filter
1. With the removed power head in the upside down position.
2. Carefully remove the reusable cloth filter from the filter cage. (fig. 4) Clean the filter by gently tapping or
brushing dirt off. Cleaning should not be done indoors in living areas.
3. Use a mild soap and water solution to wash reusable cloth filter and rinse with clean water. (fig. 5)
4. Allow the wet filter to air dry for 24 hours before installing onto the filter cage.
INSTALLING & CLEANING FOAM SLEEVE FILTER
Installing Foam Sleeve Filter
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Remove power head and place in upside down position. Follow instructions to remove cloth filter.
3. Carefully slide foam sleeve filter down over the filter cage making sure the whole cage is covered.
(fig.2 & 3)
4. Replace the power head on to the container.
Cleaning Foam Sleeve Filter
1. With the removed power head in the upside down position, carefully remove foam sleeve filter. (fig. 4)
2. Use a mild soap and water solution to wash foam sleeve filter and rinse with clean water. (fig. 5)
3. Allow filter to air dry before installing and using again.
10