Remote Control Features; And Settings - GE Appliances YR-HQ Manuel Du Propriétaire

Remote Control Features and Settings
Remote Control
8 8
3 3
4 4
1. POWER Button
Press the POWER button on the remote controller to start
or stop the unit.
2. HEAT Button
In HEAT mode, warm air will blow out after a short period
of time due to the cold-air prevention function. When FAN
is set to AUTO mode, the heat pump automatically adjusts
the fan speed according to room temperature. The
be displayed during HEAT mode.
3. COOL Button
In COOL mode, the heat pump will blow cool air. When
FAN is set to AUTO, the heat pump automatically adjusts
the fan speed according to the room temperature. The
will be displayed during COOL mode.
4. DRY Button
DRY mode is used for dehumidification. In DRY mode,
when room temperature becomes lower than setting
temperature +2°F, the Heat Pump will run intermittently at
LOW speed regardless of FAN setting. The crossed out
water droplet will be displayed during DRY mode.
5. SPEED Button
With each press of the SPEED button, the fan speed
changes as follows: LOW-MID-HI-AUTO. The remote
controller display will show the fan icon. Hold the SPEED
button for 10 seconds to go into FAN mode. Press any
other button to exit this function.
4
6. TURBO Button
The TURBO function is used for speeding up the air
flow to highest speed in heating and cooling mode. The
UI interface will display the "TURBO" icon. Pressing
the TURBO again or SPEED button will exit the Turbo
function.
7. QUIET Button
The QUIET function is used for lowing the fan speed to the
lowest speed. The control will display the QUIET icon on
the UI interface. Pressing the QUIET button again or the
FAN Speed button will exit the QUIET function.
8. TEMP +/- Button
TEMP + : The setting temperature will increase 1°F
(0.5°C) when pressed. TEMP - : The setting temperature
will decrease 1°F (0.5°C) when pressed. The range of
operating temperature is 60°F-86°F (16°C-30°C).
9. MOTION SENSOR
Press the MOTION SENSE button to activate Motion
1
Sense mode. Eco will be displayed on the screen. While
in this mode the unit will decrease the temperature set
point 1°F (0.5°C) every 20 minutes in heat mode until
it reaches 68°F (20°C) or increase the temperature set
6
point 1°F (0.5°C) every 20 minutes in cooling mode until
it reaches 78°F (26°C) or above. If motion sensor detects
7
motion in the room, it will exit the eco mode and change
the temperature or the original setpoint immediately. If
2
the set temperature is below 68°F (20°C) while in heating
mode or 78°F (26°C) while in cooling mode, this function
5
will not be able to change temperature further.
9
will
10
12
14
16
18
11
13
15
17
19
20
21
49-5000491 Rev. 0