Accessories - GMC GID850 Mode D'emploi

Drilling wood
WARNING: DO NOT inhale wood dust. Wear adequate breathing protection. Some wood dusts may be toxic.
• Use 'Conventional Rotary Drilling Mode' only
• Ensure the drill bits are suitable for wood and are within the maximum capacity of the machine - see
'Specification'
Drilling metal
WARNING: Never switch the machine to 'hammer drill mode' when drilling metal.
WARNING: The drill bit, especially the tip, will become very hot when drilling metal. DO NOT touch the bit and
never allow it to come into contact with combustible materials. Always use a suitable lubricant or cutting fluid,
and drill at appropriate speeds.
• Use 'Conventional Rotary Drilling Mode' only
GB
• Ensure the drill bits are suitable for the grade of metal being drilled, and are within the maximum capacity of
the machine - see 'Specification'
• Mark the intended hole position using a hammer and centre punch to ensure accuracy
• Apply moderate pressure only to the drill bit, ensuring efficient cutting and prolonged drill bit life
• Use a countersink bit to remove sharp burrs from the hole, preventing cuts and other kinds of injury

Accessories

• A range of accessories and consumables, including drill bits, screwdriver bits, wire brush etc, is available
from your GMC stockist. Spare parts can be obtained from toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any inspection, maintenance
or cleaning.
General inspection
• Regularly check all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should be carried out by
an authorised GMC service centre. This advice also applies to extension cords used with this tool
Cleaning
• Keep the tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and shorten the
machine's service life. Clean the body of the machine with a soft brush, or dry cloth. If available, use clean,
dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol, petrol or strong
cleaning agents
• Never use caustic agents to clean plastic parts
• Water must never come into contact with the tool
Lubrication
• Slightly lubricate all moving parts at regular intervals with a suitable spray lubricant
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• If you suspect that the brushes may be worn, have them replaced at an authorised GMC service centre
Storage
• Store this tool carefully in a secure, dry place out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional and are not
viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with household
waste
• Contact your local waste disposal authority for information on the correct way to dispose of power tools
8