Publicité
Les langues disponibles
Les langues disponibles
503 PLATINUM FM & AM
Automatic & manual with alarm
STEP 1 - CODING AM / FM TRANSMITTERS
The system can store up to 3 different remote control codes in memory.
1
LED on the module and antenna are
flashing when the unit is power on.
4
1 min
IGN
Within one minute, turn Ignition On and
within 3 seconds tap the foot brake 3
times, the LED on the module and the an-
tenna will blink rapidly.
STEP 2 - CODING ADDITIONAL TRANSMITTERS
1
x1
Press Unlock button of the existing
transmitters.
TACH LEARNING ** MANDATORY **
1
Key Start / LED stays solid.
Remote Starters and Alarm Systems
INSTALLATION GUIDE
2
IGN
Turn
the
Ignition
programming button once, you see and
hear 1 parking light and horn confirma-
tion, turn Ignition Off.
5
x3
Press the Lock button of each transmitter
you want to code one after the other. When
the unit receives the transmitter confirmation
it will flash the parking lights and sound the
horn* each time.
2
Repeat step 4, 5 & 6 of the above
section.
2
• Press and hold the Lock + Un-
lock buttons on the remote
transmitter until the parking
lights start flashing.
• Then re-lease the buttons.
x1
3
OFF
On,
press
the
Turn
programming button once, you see and
hear 2 parking light and horn confirma-
tions, turn Ignition Off.
6
(with existing transmitter)
3
NOTE :
Everytime you re-code a new transmitter you
must code all existing transmitters in
the same time or the older transmitters will be
bumped off for security reason
3
Parking lights will flash 6 times,
pause and 1 time if the tach signal is
read correctly. You will then hear 1
horn confirmation* (if horn wire is
connected). The tach is program-
med
NOTE : in manual transmission
mode the process will be the
same, except of 1 horn confirma-
tion, you will hear 6 horn
confirmation
Version 705M2 / 1214
x1
OFF
IGN
Ignition
back
On,
press
OFF
Ignition Off.
4
OFF
Ignition Off
the
*Optional
*Optional
Publicité
