General Description; Standard Mode - GYS STARTRONIC 800 Mode D'emploi

Translation of the original instructions

GENERAL DESCRIPTION

Designed for vehicles equipped with a 12V battery (6 cell 2V), this autonomous starter is equipped with supercapacitors
and uses the battery voltage of a running vehicle to recharge itself and start the engine of a broken-down vehicle in a
few seconds.

STANDARD MODE

Emergency start function for petrol or diesel vehicles equipped with a 12V battery.
To start a vehicle, please process as follows:
1 Make sure that the vehicle's battery terminals are clean, grease and corrosion free.
2 Connect the red clamp to the battery's (+) and the black clamp to the battery's (-).
3 The device switches on automatically and displays its internal voltage via the indicators (7).
Press the on/off button (key 4) before starting the charge of the STARTRONIC.
4
Full charge takes approximately 2 minutes. During the charge, the voltage indicators will blink
until they reach 14V.
When the 14V indicator stops blinking, the device is charged and ready to start your vehicle.
5
Start your engine.
ON
6
When the engine starts, remove the clamps from the vehicle.
PRECHARGE MODE
It is possible that the vehicle's battery is too deeply discharged (<5V) and will not fully charge the
STARTRONIC. In that case, the fault indicator (6) turns red during the charge.
The device can be charged in 3 different ways :
1
STARTRONIC 800
Plug the car adaptor (8) on the car's cigarette lighter socket.
Plug the other end to the STARTRONIC's entry port (3) to start the charge.
(Full charge will take approximately 2 minutes.)
EN
9