Lenze L-force 9400 Instructions De Montage page 50

5 Mechanical installation
Mounting steps
Use with 9400
Proceed as follows for the installation:
1. Prepare M5 threaded holes on the mounting plate, for instance according
to the mounting grid.
–
Always use all mounting points specified.
2. Screw the filter onto the mounting plate.
–
Use M5 screw and washer assemblies or M5 hexagon socket screws
with washers.
–
If further devices are to be mounted directly adjacent on the right−hand
side of the filter, do not tighten the screws fully before all devices are
mounted and aligned.
–
Tightening torque: 3.4 Nm (30 lb−in).
Use with i700
How to proceed during mounting:
1. Prepare M5 threaded holes on the mounting plate.
–
Always use all fixing points specified.
2. Screw the filter to the mounting plate.
–
Use M5 screw and washer assemblies or M5 hexagon socket screws
with washers.
–
Tightening torque: 3.4 Nm (30 lb−in).
50
l
EDK94AZMP0494 DE/EN/FR 2.0