Led Indicators; Install The Hardware - Axis Communications M1143-L Guide D'installation

AXIS M1143-L/M1144-L

LED indicators

LED Color
Network Green
Amber
Unlit
Status Green
Amber
Red
Power Green
Amber

Install the hardware

1. Attach the stand to the camera by screwing it on. For wall
mounting, attach the stand to wall first, using 3 appropriate screws.
2. Attach the cable to the network connector (supports PoE class 2) in
the camera.
3. Check that the indicator LEDs indicate the correct conditions. See
table above.
Note:
Make sure the light sensor is not covered; this could affect its
performance and lead to false Day/Night shifts.
Indication
Steady for connection to a 100 Mbit/s network. Flashes
for network activity.
Steady for connection to 10 Mbit/s network. Flashes for
network activity.
No network connection.
Steady green for normal operation.
Note: Configure the Status LED to be unlit during normal
operation, or to flash only when the camera is accessed
from Setup > System Options > LED. See the online help
files for more information.
Steady during startup, reset to factory default or when
restoring settings.
Slow flash for failed upgrade.
Normal operation.
Flashes green/amber during firmware upgrade.
Page 7