Harmony Hub Interface; Compatibility & Orientation - NuVinci OPTIMIZED Harmony 330 Manuel Technique D'utilisation

6.6 Harmony Hub Interface Compatibility
6.6 Harmony Hub Interface
TM
& Orientation
Compatibility & Orientation
1. Ensure you have the correct Harmony Hub
Interface for your NuVinci Optimized CVP.
•
N330/N330f CVPs have a yellow dot (A),
and are compatible only with HHI3 Hub
Interfaces (B, for Harmony systems).
•
N360 and N380/N380 CVPs have
SE
a black colored shift driver (C), and are
compatible only with HHI8 and H|Sync
Hub Interfaces (D, for Harmony 380 and
Harmony H|Sync systems).
2. Use the uninstalled Harmony Hub Interface
(E) to determine the desired orientation
•
Orientation should be forward, parallel
to the chain stay with the Harmony main
connector facing forward.
•
Move the Harmony Hub Interface along
the dropout to ensure clearance at different
axle positions.
3. With the Harmony Hub Interface oriented
correctly inside the right dropout, the
installation angle (F) is the indicated
angle of the dropout (20 degrees in this
example).
•
Use the markings on the Harmony Hub
Interface to determine your approximate
installation angle.
TECHNICAL OWNER MANUAL
N330/N330f CVP
A
N360/N380/N380 CVP
SE
C
0°
E

Harmony Hub Interface 3

compatible B
Harmony Hub Interface 8
D
compatible
20°
HARMONY ASSEMBLY OF COMPONENTS
Harmony Hub Interface Sync
D
N330/N330f and N360/N380/

0°
!
N380 series CVPs have different
SE
shift driver configurations, and are
compatible only with the appropriate Harmony
F
Hub Interface. Do not attempt to fit incorrect
Harmony Hub Interfaces, as damage will
occur.
EN
16