Hoses And Fittings; Typical Setup; Hose Connections - Greenlee AML Serie Manuel De L'utilisateur

Hoses and Fittings

Installation and Maintenance
See publication 99930323, SAE Standard J1273
(Hose and Hose Assemblies).
Replacement
See a Greenlee catalog or Greenlee publication
99910322, Low Pressure Quick Couplers,
Adapters and Hoses.
Do not disconnect tool, hoses, or fittings while
the power source is running or if the hydraulic fluid is
hot. Hot hydraulic fluid could cause serious burns.

Typical Setup

Greenlee Tools, Inc.
Hydraulic Rotary Impact Drill

Hose Connections

Tool Port Identification
One of three methods is used to identify the pressure
and tank ports of Greenlee tools. Match the markings on
your tool to this table.
Pressure Port
P
In
Connecting Hoses
1. Move the flow lever on the hydraulic power source
to the OFF position.
2. Stop the hydraulic power source.
3. Connect the tank hose to the tank port on the
power source, and then to the tank port on the tool.
4. Connect the pressure hose to the pressure port on
the tool, and then to the pressure port on the power
source.
Disconnecting Hoses
1. Move the flow lever on the hydraulic power source
to the OFF position.
2. Stop the hydraulic power source.
3. Disconnect the pressure hose from the power
source, and then from the tool.
4. Disconnect the tank hose from the tool, and then
from the power source.
5. Install dust caps over the ports to prevent
contamination.
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Tank Port
T
or
Out