Important - Rotary ARO14 Instructions D'installation

D. Start yoke end into the column, allowing slider bolt
holes to stay exposed, Fig. 8. Bolt sliders onto each side
of the yoke end with M8-12 screws provided. When
both sliders are attached, push column toward yoke
end until sliders touch latch bar.
E. Raise latch bar above sliders and move column toward
yoke until the sliders contact the back of the column.
Latch Bar
Column
Slider
Yoke
Fig. 8
M10-16 Bolt
10mm Lock Washer
Sheave Pin Retainer
Pull Latch Bar up
above sliders.
M8-12
Countersunk
Screws
Plastic Push Rivet
Plastic Guard
Plastic
Sheave
Spacers
Pin
Sheave
SHEAVE INSTALLATION
Lower the latch bar into the sliders. Tighten latch
bar jam nut against column top plate. Run latch bar
adjustment nut down and tighten. The latch bar should
engage the sliders for at least 1" (25mm) when the lift is
completely lowered. Repeat this procedure for each
rear yoke end and column.
F.

IMPORTANT

groove. Attach each cable to column top plate with
washer, nut, and jam nut, Fig. 9. Install plastic sheave
guard on each yoke end. Roping diagram shows a view
of completed roping, Fig. 4.
Note: Failure to install plastic spacers and bearings will
result in premature failure and void warranty.
6. Front Latch Bar Install:
Note: Front columns are the taller columns.
A. Place power unit column at the left front corner of lift.
B. Install latch bars into front columns following Steps
5(A) to 5(C). Secure bottom of latch bar with long bolt,
washer and nut, Fig. 10.
C. Place FRL Bracket on top of power unit column. Guide
the threaded stud through the hole in the column top
plate and bracket, Fig. 7a.
Jam Nut
Nut
Washer
Latch Bar
Adjustment Stud
Side Plate
Yoke
End
TOP VIEW (top removed)
5
Be sure cable is isolated in the sheave
Column
Plastic
Spacers
Sheave
Yoke
Fig. 9