Publicité
Les langues disponibles
Les langues disponibles
assembly instructions
Footrest
pad
Swivel shaft
Plastic
cover
Step 1
Pad
1. Remove contents from box.
2. Pull legs in opposite
direction until locking but-
ton "snaps" into locking
receiver (See figure A).
After removing all the
3. Attach digital display to the
peddler by sliding the loop
plastic wrapping insert
over the tension knob recep-
the tension adjustment
tacle located on the top of
bolt into the top of the
the peddler. Push down gently
central housing and
on the display so the clasp on
lightly tighten.
the back of the display attach-
es to the peddler frame. (See
figure B)
4. Insert tension knob on top of peddler and turn
clockwise to tighten. The tension knob will increase/
decrease the amount of tension on the peddler.
Tighten/ loosen to a level that feels comfortable.
5. The pedal straps have
2 sets of holes to allow you
Step 4
to adjust the length of the
strap around your foot or
shoe. (See figure C)
Rev.2.12.02.15
Tension knob
Digital Display
Footrest plate
Hinge
Connecting
Tube
Tube
figure A
figure C
To fold, depress push pin and fold leg inward. Repeat
for second leg. (see figure D)
Step 2
1. MODE (Red Button): This control
allows you to select a particular
function. To start, press and hold
the Red Button for 4 seconds. The
LED will display the different func-
tions. (After a few minutes without
any movememnt, the unit will
automatically shut off).
2. To select a function, wait until the
4 second set up is complete. Push
the Red Button and the arrow will move through the func-
tions. When the desired function is selected, simply use the
Unfold each of the
peddler and the unit will calculate the exercise.
lower leg sections and
3. TIME: Determines the amount of time the peddler has been
ensure the spring
operating.
release buttons are
4. COUNTER (CNT): Determines the amount of steps while
engaged / clicked into
operating the peddler.
place.
5. CALORIE (CAL): Determines the amount of calories burned
while using the peddler.
figure B
6. REPS PER MINUTE (R.P.M.) Automatically calculates the
repetitions per minute.
7. SCAN: Will automatically review the results of all functions.
If the display does not come on or reads incorrectly, the bat-
tery requires replacement.
To replace the battery, use a small screw driver and remove
Finished Assembly
the display panel. Turn the display panel over and remove the
watch- style battery. Insert a new battery and replace the
display panel.
WARNING—DEVICE MAY BECOME HOT WITH EXTENDED USE.
folding
Operating Gu
automatic operation
Counter 1
Press the MODE /
RESET button on the
multi-function counter to
turn it on. Press it
again to select the
TIME, CAL and RPM
displays.
battery replacement
Care when folding
figure D
S
Publicité
