The Galley Ideal Workstation Guide D'installation page 7

1. CONSTRUCT SUPPORT STRUCTURE
a) A wood support frame (cleat system) will need to be
built and installed into the cabinet(s). This frame will
support the weight of The Galley.
NOTE: Clips are NOT to be used.
b) Construct the support frame so that the inside
dimensions of the frame are 1/2" larger than the basin's
inside dimensions. Please refer to pages 1-4 for your
Galley dimensions.
NOTE: For a Galley + DryDock™, the support frame
must be built with 1" x 2" boards.
2. ATTACH THE SUPPORT FRAME TO THE
INTERIOR WALLS OF THE CABINET
**IMPORTANT**
Support frame must be installed 1/16" lower than the
top of the cabinet. Use a level to ensure that the
support frame is installed level in the cabinet. Once
installed, the top of the Galley Basin Flanges will be
flush with the top of the cabinet.
3. INSTALL THE WORKSTATION BASIN
a) Carefully place The Galley Basin into the cabinet
by resting the flanges on the support frame. All four
flanges should rest on the support frame.
b) Use a level to ensure that the flanges are level.
c) The top of the flanges should be flush with the top
of the cabinet.
d) Measure to ensure that the Galley site squarely in
the cabinet.
1" x 6" HARDWOOD BOARDS ARE RECOMMENDED
EXCEPT FOR GALLEY + DRYDOCK, FOR
WHICH 1" X 2" ARE RECOMMENDED.
6
OVERHEAD VIEW