Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The blower starts all by itself
1. A drying cycle starts automatically 20 minutes after the complete
shutdown of the system. This blows air in the piping for approximately
1 minute (or more depending on program configuration) to dry
the tubing and jet heads. If you interrupt the drying cycle by pressing
the on/off button you re-start the cycle countdown and it will start
again automatically in 20 minutes.
- The drying cycle may start automatically after a power failure or an
intentional interruption of power on the circuit feeding the system.
- If your system is equipped with water level detectors, the drying
cycle will be initiated 20 minutes after emptying the bathtub even
if the system was not used.
WARRANTY
All air blowers are warranted to be free of defects in manufacturing,
material and workmanship for a period of one year from the date of
purchase by the owner/end-user.
Limitations
This warranty does not apply to the bath tub and/or spa but solely to
the components manufactured by CG AIR SYSTÈMES INC.
This warranty shall not apply to the following incorrect operating
procedures, breakage or damages caused by fault, abuse, misuse,
carelessness, misapplication, alteration, modification, improper
maintenance of the unit, as well as act of God, fire, chemical or
natural corrosion or any other casualty.
The owner of the product covered by the present warranty is entirely
responsible for the proper installation of the product in accordance
with the installation manual provided. CG AIR SYSTÈMES INC. neither
ELECTRICAL INSTALLATION
1. The electrical installation is subject to inspection and approval by local authorities. All electrical connections must be made by a licensed electrician.
2. Before beginning installation make sure that electric power is disconnected at fuse box.
3. The blower must be located out of reach from the person in the bathtub and fixed in position with screws.
4. The blower connection is pre-installed. Do not remove the blower cover, this will void the warranty.
5. Refer to your local electrical code if your distance between the installation site of the bath unit and the main fuse box is more than 100 feet (30,4 m).
120V
Use the factory pre-installed type SJ wire to connect to junction box (not provided by the tub manufacturer). Run a separate
120V, 60Hz, 15A G.F.I. (Class A protected) electric circuit from the main fuse box to the junction box. Use a 14 gage three conductor
cable (2 wires plus ground) in connections up to 100 feet (30,4m) from the main fuse box.
SYSTEM FUNCTIONS & CONNEXIONS
Refer to the attached instruction sheet for complet information on the functions and connexions.
OPTIONAL REMOTE CONTROL
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
installs nor supervises nor contracts for the installation and
consequently cannot be held responsible for the installation.
CG AIR SYSTÈMES INC. is not responsible for any damages or claims
resulting from defects that could have been discovered, repaired or
avoided by inspection and testing prior to installation.
CG AIR SYSTÈMES INC. makes no express warranty , no warranty for
merchantability, no warranty of fitness for particular purposes, neither
any other warranty implied or statutory for its products other than
specified above.
In no event shall CG AIR SYSTÈMES INC. liability exceed the purchase
price of the defective part.
If within the warranty period, any such product shall prove to be
defective, CG AIR SYSTÈMES INC. reserves the right to repair or replace
the defective product with one of equal value.
Commercial limitations
In addition to the above conditions and limitations, if the product is
to be used as a display, the warranty period begins when the product
has been placed on display. Under no circumstances will
CG AIR SYSTÈMES INC. be responsible for any profit loss due to a
malfunction of the unit. This warranty gives the owner/end-user specific
legal rights and the owner/end-user may have other rights which
vary from one state/province to another.
CG AIR SYSTÈMES INC. reserves the right to discontinue and/or change
models, colors and specifications in design together with replacement
parts without notice and without incurring any obligations.
3
Publicité
Table des Matières
