ELAC Debut 2.0 Dolby Atmos Mode D'emploi page 7

Dolby Atmos Speaker Configurations
There are three basic Dolby Atmos configurations when using the A4.2 add-on speakers.
• 5.1.2 Setup - This configuration uses a pair of A4.2s in addition to your existing 5-channel speakers. The
pair of A4.2s would be added to the front left and right speakers as height channels.
• 5.1.4 Setup - This configuration uses two pairs of A4.2s in addition to your existing 5-channel speakers.
The A4.2 would be adding both front (left and right) and rear (left and right) as height channels.
• 7.1.4 Setup - This configuration uses two pairs of A4.2s in addition to your existing 7-channel speakers.
The A4.2 would be adding both front (left and right) and rear (left and right) as height channels.
In all configurations, a set of A4.2 speakers is allocated to the front left and right speakers. The ideal position is
directly on top of your existing speakers. In the event that the A4.2 cannot be placed on top of your speakers
due to restrictions, place it within 2-3 feet of your left and right speakers. Additionally, the height should be as
high as or within 18 inches above the left and right speakers.
Dolby Atmos
5.1.4 Channel System
Configuration
Side or Rear Application in a 5.1.4 or 7.1.4 system:
Place the A4.2 on top of the rear left and right speakers. If restricted, place them within 2-3 feet and the same
height or at least 18 inches above or below the speakers.
If you need additional guidance on a more elaborate speaker setup or need more information on Dolby Atmos,
please visit http://www.dolby.com/us/en/technologies/dolby-atmos.html.
Wiring/Level Setting:
Follow the receiver/amplifier instructions for appropriate wiring of the A4.2. When setting up and matching
the output level, refer to the users manual of your receiver/amplifier. Complete the setting based on the
configuration of your system and the recommendations given by the receiver/amplifier manufacturer.
Caution: Overpowering may cause failure to the A4.2 speakers. Always be responsible when listening to your
speakers at extremely high volume as they can cause hearing damage or loss.
ELAC Debut A4.2 Speakers | www.elac.com | Page 6
Dolby Atmos
7.1.4 Channel System
Configuration