marklin 89 70-75 Serie Mode D'emploi page 10

Setting Locomotive
Parameters with the
Control Unit
1. Requirement: Setup as
in diagram 1. Only the lo-
comotive to be changed
can be on the track.
2. Press the "Stop" and
"Go" at the same time
until "99" blinks in the
display.
3. Press the "Stop" button.
4. Enter the address „80".
5. Hold the speed control
knob in the reverse direc-
tion position constantly.
Press the "Go"
button while
80
you do this. The
headlight on the
locomotive will
1
blink. If no, repeat
starting at Step 2.
Diagram 1
99 1
1
80
1
2
1
6. Enter the register number
for the parameter to be
changed (=> List 1).
7. Activate the direction
reversal.
8. Enter new value
(=> List 1).
9. Activate the direction
reversal.
10. End the procedure by
pressing the "Stop"
button. Now press the
"Go" button.
List 1: parameter
Address
Acceleration delay
Braking delay
Maximum speed
Reset to series values
Volume
10
Betrieb • Operation • Fonctionnement • Exploitatie
01
2
01
1
1
1 10
10
2
1
Register Number
Value
01 01 - 79
03 01 - 63
04 01 - 63
05 01 - 63
08 08
63 01 - 63