Outdoor Unit (Doorbell); Installation; Mount The Indoor Unit (Monitor); Mount The Outdoor Unit (Doorbell) - Byron DIC-23312 Manuel D'instructions

2. Speaker
3. Home button
4. Touchscreen
5. MicroSD card slot
2.3

OUTDOOR UNIT (DOORBELL)

1. Microphone
2. Camera
3. Speaker
4. RFID
5. Call button (replaceable, extra button included)
6. Lock release time switch
7. Doorlock / gate switch
8. Register button (On the back of the unit)
3

Installation

3.1

MOUNT THE INDOOR UNIT (MONITOR)

To mount the monitor, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. Pull the required cables through the mounting plate.
F. Fasten the mounting plate with the screws.
G. Attach the monitor to the mounting plate.
3.2 MOUNT THE OUTDOOR UNIT
(DOORBELL)
To mount the outdoor unit, you will need the following tools:
ü A suitable screwdriver for the included screws.
ü A drill and suitable drill bit for the included screw plugs.
A. Position the provided mounting plate where desired.
B. Mark the screw positions with a pen.
C. Drill the necessary holes.
D. Insert the plugs.
E. Use a knife or sharp object to puncture the cable gland.
F. Pull the required cables through the cable gland.
G. Fasten the mounting plate with the screws.
H. Attach the outdoor unit to the mounting plate.
I. Fasten the screw at the bottom.
3.3

ELECTRICAL INSTALLATION

To connect the terminals, you will need the following tool:
ü A small screw driver.
A. On the indoor unit (monitor): Loosen the terminal screws (see
sticker on the monitor for position).
B. Place the wires.
C. Fasten the terminal screws.
D. On the outdoor unit (doorbell): Loosen the terminal screws (see
sticker on the doorbell for position).
E. Insert the wires.
F. Fasten the terminal screws.
Instruction manual
EN
7