System Information; Reset; Insert Sd Card; Firmware Update - Byron DIC-23312 Manuel D'instructions

Instruction manual

7.4.7 System information

7.4.8 Reset

8

Insert SD card

Make sure the device is not connected to the power adapter
when inserting the SD card.
ü The SD card is required for recording footage (including cloud
storage) as well as continuous firmware updates of the device.
Follow below procedure to insert the SD card:
A. Remove the 3 securing screws located at the back of the doorbell
and remove the rubber seal.
B. Slide the doorbell up and out of the aluminum case.
C. On the side of the doorbell you can find the SD card slot. Remove
the rubber seal and insert the SD card (max. 128GB), then push
the rubber seal back into place.
D. Slide the doorbell back into its aluminum case and replace the
securing screws.
9

Firmware update

Your doorbell will receive over-the-air updates. You will be notified in
the app when an update is available. Follow the on-screen
instructions to download and install the update. You must have
inserted an SD card for this to work.
14
10 Trouble shooting
• Check our extended manual online for further information:
www.chbyron.eu/doc
• Check our installation video online: www.chbyron.eu/doc
• Contact us directly for support or questions.