Mains Connection; Switching On; 2-Speed Gearing; Changing Gears - B+BTec Diamond3 professional MX11 Manuel D'utilisation

MAINS CONNECTION

Make sure you connect the mixer to
a power supply that corresponds with the
mixer (see sticker on the machine).
• Do not use damage cables.
• All cables should have a diameter of
at least 3 x 1,5 mm² for a total cable
length of 25m
Main Fuse: 10 A

SWITCHING ON

Do not use a machine that cannot be
switched ON or OFF. Damaged switches
should be repaired or replaced by an
authorized service center.
Switching ON
Press the ON/OFF switch (3). the mixer
will start to rotate. Increased pressure on
the switch will increase the rotating speed
of the whisk.
Switching OFF
Release the ON/OFF switch (3).

2-SPEED GEARING

The mixer is equipped with a 2-speed
gearing:
1st gear: 0 min to 380 min
–1
2nd gear: 0 min to 660 min
–1
Only change gears when the mixer is
turned OFF and the whisk has come to a
complete stop.

Changing gears

Turn the gear swith (5) to the speed of your
choice.
1st gear: 0 min to 380 min
–1
2nd gear: 0 min to 660 min
–1
DIAMOND3
–1
–1
–1
–1
MX11
®

WORKING WITH THE MIXER

• Use whisks recommended by the
manufacturer only.
Maximum diameter: Ø 160mm
• The whisk that is supplied with the
mixer is suited for the following materi-
als: building compounds such as adhe-
sives, paste, glue, knifing filler, plaster,
tile cement etc.
• Increase the speed during the mixing
process. Immerse the whisk through
the material until it is thoroughly mixed.
Follow the processing instructions from
the supplier.
• Hold the mixer with both hands during
mixing.
• Do not reach into the rotating whisk.

MAINTENANCE

!
Prior to any maintenance or cleaning
work:
– Turn the mixer OFF.
– Wait for the whisk to come
to a complete stop.
– Pull the power plug.
• Use original spare parts only. The use
of other parts may lead to damage or
injury.
• More complicated repairs should be
done by the manufacturer or an author-
ized service center.
• Store unused machines in a locked dry
place and out of reach of children.
!
For continued smooth operation fol-
low the maintenance instructions:
• Ventilation slots should be kept open
and clean.
• Remove dust and dirt using a cloth or
a soft brush.
• Do not clean the machine with running
water or highpressure cleaners.
17
GB