Special Tools Safety Warnings - B+BTec Diamond3 professional UDK68 Manuel D'utilisation

GB
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g) Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool
for operations different from those
intended could result in a hazardous
situation.
5) Battery tool use and care
a) Recharge only with the charger
specified by the manufacturer. A
charger that is suitable for one type of
battery pack may create a risk of fire
when used with another battery pack.
b) Use power tools only with specifically
designated battery packs. Use of any
other battery packs may create a risk
of injury and fire.
c) When battery pack is not in use, keep
it away from other metal objects, like
paper clips, coins, keys, nails, screws
or other small metal objects, that can
make a connection from one terminal
to another. Shorting the battery
terminals together may cause burns or
a fire.
d) Under abusive conditions, liquid may
be ejected from the battery; avoid
contact. If contact accidentally occurs,
flush with water. If liquid contacts
eyes, additionally seek medical help.
Liquid ejected from the battery may
cause irritation or burns.
6) Service
DIAMOND 3
a) Have your power tool serviced by a
b) For power tools with type X
SPECIAL TOOLS SAFETY
WARNINGS
NOTE: The above warning applies only to
impact drills and may be omitted for drills
other than impact drills.
Cutting accessory contacting a "live"
wire may make exposed metal parts of
the power tool "live" and could give the
operator an electric shock.
• Always use coolant water
10
UDK68
®
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
attachment, where a specially
preparde cord is needed to replace
the cord: if the supply cord of this
power tool is damaged, it must be
replaced by a specially preparded
cord available through a qualified
service facilty.
Wear ear protectors
when impact drilling.
Exposure to noise can
cause hearing loss.
Before working on the machine
itself, pull the mains plug.
WARNING: Use auxiliary
handle(s) supplied with the tool.
Loss of control can cause person-
al injury.
Hold power tool by insulated
gripping surfaces, when per-
forming an operation where the
cutting accessory may contact
hidden wiring or its own cord.
when drilling.