osann LUPO PLUS Mode D'emploi page 18

Fitting the car seat for 9-18 kg with the 3-point-seat belt
1.
4.
1. Place the child safety seat on the vehicle's seat ensuring it is firmly pressed against the car seat back-
rest.
2. Thread the car seat belt in through the seat belt route slot in the seat's plastic backrest furthes from
the car's seat belt buckle, and the out through the other seat belt route slot and fasten it into the
seat belt buckle.
3. Check the webbing of the seat belt has not become twisted or tangled and that the lap belt goes
under the armrest and the diagonal belt under the headrest belt guide then goes over the red belt
guide on the side of the backrest.
4. Place your knee on the base of the safety seat and grip the top piece of seatbelt webbing. Pull the
webbing upwards to tighten the seat belt.
5. Finish tightening the webbing by pulling the diagonal strap upwards until there is no slack and the
seat is held firmly in place. Now you can strap your child into the seat.
Make sure the seat belt has not become twisted.
To release your child seat follow the above instructions in reverse order.
3.
EN
2.
5.