osann LUPO PLUS Mode D'emploi page 14

EN
Correct shoulder strap height
Belt too low Belt too high Correct
Always check the shoulder straps are at the correct height for you child. The child's shoulders
should always be below the slot for the harness.
Changing the shoulder strap height
Firstly, release the strap holding the backrest cover on to gain access to the harness. Slide one of
the harness straps off the harness connector. Then from the front of the seat, pull it through the
slot in the seat's backrest and fabric cover. Thread the harness strap back through the next hole up
or down on the seat's backrest.
Re-thread the harness strap back onto the harness connector at the back of the seat.
Repeat the same process for the other harness strap. Make sure both of the straps go through
slots at the same height.