Assembling The Fertilizer Spreader; Functioning Of The Machine - AGREX SP50 Emploi Et Entretien

YOU ARE ADVSED NOT TO:
• load the hopper with wet products as these may clog the machine.
• use the spreader to scatter stones or other dangerous materials.
• dismantle safety devices and the covers protecting them.
• transporting people is prohibited both while working and during transfers.
The fertilizer spreader must never be used by employees under the age of eighteen.
7

- ASSEMBLING THE FERTILIZER SPREADER

Pay attention while assemblying the spreader. The operators must be instructed
on the hazards and the precautionary measures to be taken. Use safety gloves
and tools suitable for the operation to be carried out.
A - Assemble shafts 3-4 and 5 on the transmission unit, with the same rotation direction as shown in
the drawing.
B - Fix the transmission unit 1 to the frame 2.
C - Fix the drawbar 6 to the frame 2.
D - Fix the tie-rod 7 and the casing P to the frame 2.
E - Fit the disc 8 on the central transmission shaft.
F - Fix the fertilizer opening lever 9 to the bow on the frame 2.
G - Fit the space washer 10 on the unit axle .
H - Fix the wheels 11 to the unit axle.
I - Fit the agitator guide bushing 15 in the hopper cone, with the doser disc, the sealing washer and
the snap ring. (N°12) .
L - Introduce the agitator 13 into the central hole in the hopper 14 and fix it to the shaft 5;
M - Connect the opening tie-rod 16 to the doser disc 8 and the opening lever 9.
8

- FUNCTIONING OF THE MACHINE

HITCHING
The machine can be attached to any type of self-propelled vehicle or tractor which is sufficiently powerful.
Position the tractor close to the machine, apply the handbrake and secure the drawbar to the tractor using
the special pin (Fig.6 pag.30).
NOTE: When the spreader is attached to the tractor the blades are activated and
start moving
ENGLISH
(Fig.5 pag.30)
USER'S GUIDE
SP
21