Inspection And Monthly Maintenance - Dometic DF Serie Instructions D'utilisation

OPERATION
B. Turning Off The Furnace
FIG. 1
Furnace
(Small Vent)
Thermostat
• Set the thermostat to the lowest setting, then turn to the OFF position .
• Turn the manual shut-off valve at the LP tank (if equipped) to the OFF position . Do NOT force the valve .
• At the exterior access panel, turn the switch on the Furnace to the OFF position .

INSPECTION AND MONTHLY MAINTENANCE

 ELECTRICAL SHOCK, FIRE, OR EXPLOSION HAZARD . Failure to obey the following warnings could result in
dangerous operation, property damage, serious injury, or death:
• Never attempt to repair the Furnace yourself . Contact a qualified service technician .
• Improper servicing could result in dangerous operation, serious injury, death, or property damage .
• Before servicing, disconnect all electrical power to the Furnace .
• When servicing the controls, label all the wires prior to disconnecting . Reconnect the wires correctly .
• Verify proper operation after servicing .
• Keep the Furnace, control compartments, burners, and circulating air passageways clean and unobstructed . More frequent
cleaning may be required from excessive lint from carpeting, bedding materials, pet hair, etc .
• Do NOT use petroleum or a citrus-type cleaner on plastic parts, as damage may occur .
The motor is permanently lubricated and requires no oiling .
A. Servicing And Maintenance
Annual inspections should be performed by a qualified service technician .
MONTHLY
To be performed by owner/user:
VENTS AND EXHAUST TUBES
Exhaust Tubes" on page 6 .
CHAMBER:
Refer to "C . Inspecting The Chamber" on page 6 .
MOUNTING BASE:
Refer to "D . Inspecting The Base" on page 6 .
VENT ASSEMBLY:
Refer to "E . Inspecting The Vent Assembly" on page 6 .
Power Switch
: Refer to "B . Inspecting The Vents And
FIG. 2
Thermostat
*Switch is located behind door
ANNUALLY
To be performed by qualified service technician:
Refer to "Annual Maintenance" on page 7 .
5
*Power Switch
Furnace
(Door Model)