Controls And Functions - Fbt StageMaxX 12Ma Mode D'emploi

CONTROLS AND FUNCTIONS

UK
ON
Indicates that the system in on.
PK
When this led lights up it indicates that the signal is reaching saturation. Adjust signal level until the led turns off and
stays off.
PRT / LMT
If this led lights up, there is a system malfunction due to an internal amplifier failure or to the intervention of current
limiting circuits against thermal overload. The occasional led lighting up during highest signal peaks does not imply
any troubles in system proper operation; if the led stays on, lower the signal; if the led stays on even without any
signal, the system is in safe mode; then, switch the system off, wait approximately for 1 minute and switch it on
again.
HP FILTER
This switch activates the low-cut filter, which lets only the frequencies above the cut-off frequency pass at the
output.
IN - LINK
Balanced input/output XLR sockets; «IN» allows for the connection of a pre-amplified signal, such as, for
instance, the signal coming from mixer output. «LINK» allows for the connection of multiple speakers to the
same signal.
LEVEL
It adjusts signal general level.
PRESET
It is used to select 4 presets, each one corresponding to a different equalization according to the personal
preferences and to the acoustics of the environment; the existence of presets controlled by the DSP allows to
change speaker response much more accurately compared to the tone controls; moreover, the presets are already
designed and optimized in anechoic chamber in order to provide the speaker precisely with the desired
characteristics:
Default preset for using the speaker as a "stage monitor" in floor installations. The half-space sound
ORIGINAL:
emission, and the consequent increased load on low-frequencies, is balanced aiming at a neutral response with
high sound presence.
HI-CUT / DRUM FILL:
mid-high frequencies may result unpleasant, making sound listening more difficult and distracting artists from their
performance. This preset reduces these frequencies, guaranteeing a natural and pleasant sound, even at high
SPL. It has been also designed for being used as a drum fill for drummers, with the monitor placed on the
subwoofer.
LO-CUT / DOUBLE:
may make monitor sound less intelligible. This preset reduces low frequencies, making monitor sound clearer and
increasing its presence. It is also useful when two monitors are used in a stereo configuration (right and left), for
instance for the singer, and allows to obtain a more balanced response for low frequencies.
Use this preset in case of pole or wall/ceiling installation of the monitor by means of the optional accessory, as
FOH:
14 well as, more in general, for all front of house applications.
Considering the high volume levels and the typical near field position of the monitor, some
On the stage there are often excess low frequencies returning from the master system, which
MADE IN ITALY
220-230V
50 60Hz /
T2.5AL 250V
P . C. : 450VA