Unpacking The Assembling Electric Bicycle - HITWAY BK1-HW Manuel De L'utilisateur

(3) Current battery voltage: the real-time battery output voltage is displayed in the mileage area.
(4) Total mileage ODO: display the accumulated total mileage, the display unit is km or mile.
(5) Single mileage TRIP: display the mileage of this trip, the display unit is km or milel.
(6) Turn handle PWM output: turn handle output signal to PWM thousandth ratio.
(7) Current gear: ECO-low gear, MID-mid gear, HIGH-high gear.
(8) Fault: display fault codes.
7. The fault codes are as follows:
(1) E001: The instrument cannot receive the data of the controller or the received data is the wrong
data.
(2) E002: The controller cannot receive the data of the instrument or the received data is the wrong
data.
(3) E003: controller failure
(4) E004: Motor Hall failure
(5) E005: Motor phase failure
(6) E006: turning handle failure
(7) E007: brake handle failure
(8) E008: booster sensor failure
(9) E009: The motor is under voltage protection
Warning:
using unapproved parts or not installing parts may cause damage or personal injury to the electric
bicycle. In order to ensure quality and safety, all parts of the company's electric bicycles must be
approved by the company and ensure that they are correctly installed on the electric bicycle.

2.5.Unpacking the assembling electric bicycle

Straighten the direction pole in the direction as shown in the gure, and lock the folding handle as
shown in the gure (as shown).
-4-
English / German / French / Spanish / Italian / Dutch / Japan
Https://www.LikeSporting.com