Reset To Factory Default Settings - Axis F44 Guide D'installation

Reset to Factory Default Settings

Important
Reset to factory default should be used with caution. A reset to
factory default will reset all settings, including the IP address,
to the factory default values.
Note
The installation and management software tools are available on
the CD supplied with the product and from the support pages on
www.axis.com/techsup
To reset the product to the factory default settings:
1. Disconnect power from the product.
2. Press and hold the control button and reconnect power. See
Hardware Overview on page 10.
3. Keep the control button pressed for about 15–30 seconds until
the status LED indicator flashes amber.
4. Release the control button. The process is complete when the
status LED indicator turns green. The product has been reset to
the factory default settings. If no DHCP server is available on
the network, the default IP address is
5. Using the installation and management software tools, assign
an IP address, set the password, and access the video stream.
Note
To reset a single channel to the original factory default settings,
use the button provided in that product's webpage.
It is also possible to reset parameters to factory default via the web
interface. Go to Setup > System Options > Maintenance.
AXIS F44 Main Unit
192.168.0.90
21