Kimberly-Clark PROFESSIONAL ICON Manuel D'utilisation page 3

Install Bracket
Enclosed**
For push buttons and other available parts,
contact your sales representative.
1. With a measuring tape, measure at least
55 1/2" from the floor to the bottom of
the mounting bracket. Allow 2 3/4" of
space from the wall to either side of the
widest point of the bracket. Allow 3" of
space from top of the bracket. If installing
above a countertop, allow at least 19 1/4"
of space from the bottom of the bracket.
Ensure the required clearance space is
free of obstructions for proper dispenser
installation. Check for regional & local
installing/mounting requirements.
2. Carefully brace the mounting bracket in
place once it is properly located on the
wall and mark holes to drill. Make sure the
built-in level on the bracket reads level.
3. Remove the bracket from the wall,
leaving just the four marked holes. Drill a
hole in each of the four marked locations
so anchors can be inserted.
4. Tap in the four anchors in each drilled
hole so the bracket can be screwed to
the wall.
5. Bring back the mounting bracket and
insert a screw into each wall anchor to
secure the mounting bracket to the wall.
Be sure to screw the mounting bracket to
the wall starting with the top right hole.
Make sure not to over-tighten the screw
and damage the bracket.
** Ensure that proper mounting hardware
is used for appropriate wall composition
as enclosed hardware may not be
compatible with your wall surface.
Tools Required:
1. 1.
3" (8cm)
2 ¾" 2 ¾"
(7 cm) (7 cm)
19 ¼"
(49 cm)
to counter
55 ½"
(141 cm)
to floor
3.
5.
2.
4.
2 1
3 4