Response Of Leds (Table 1); Operation Of Button (Table 2); Meaning Of Terminal Numbers (Table 3); Troubleshooting - Astrel Group Energy Meter 3 Manuel D'installation Et D'instructions

4.

Response of Leds (table 1)

Led Colour Status
Green Blink
-- --
Green Blink
Green Permanently alight
Green Permanently alight
Green Blink
Red Permanently alight
5.

Operation of button (table 2)

Function Command
Press briefly
Pairing
(1 s approx)
Press and hold
Unpairing
(15 s approx)
Press and hold
Reset
(30 s approx)
6.

Meaning of terminal numbers (table 3)

Terminal Meaning
1 SIG + (CT L1), red wire
2 SIG - (CT L1), black wire
3 SIG + (CT L2), red wire
4 SIG - (CT L2), black wire
5 SIG + (CT L3), red wire
6 SIG - (CT L3), black wire
7.

Troubleshooting

1) There is no reading of power generated by the photovoltaic system
Check that only the phase wire passes through the CTs of the Energy Meter RC
9
Turn the direction of the CTs through 180 degrees
9
2) Grid power transfer is not being read correctly
Check that only the phase wire passes through the CTs of the Energy Meter
9
Turn the direction of the CTs through 180 degrees
9
3) The reading of the power drawn by the load is a negative value
Turn the direction of the CTs through 180 degrees
9
4) During the Energy Meter RC pairing procedure, no other device is detected
Check that the ZigBee communication Led (table 1) lights up in blink mode
9
Check the distance between Elios4you [Pro] Smart and Energy Meter, and if necessary, move the meter closer or install a repeater
9
Meaning
Frequency proportional to the power read by way of the CTs
Not used
ZigBee communication: device not paired with the network
ZigBee communication: device paired correctly with the network
Power supply
Transfer of information to Elios4you [Pro] Smart system
Device not connected to the Elios4you [Pro] Smart system
Meaning
Activates pairing of Energy Meter RC with Elios4you [Pro] Smart.
Energy Meter RC no longer paired with Elios4you [Pro] Smart
The Reset function restores the parameters of the device to the factory settings. All stored
data will be deleted
15
EN