First Power-Up; Check Installation; Operation - Astrel Group Energy Meter 3 Manuel D'installation Et D'instructions

EN

First power-up

8) Supply power to the Energy Meter RC
9) Check that the ZigBee communication Led
alight, run the unpairing procedure using the button (table 2)
10) Start the "Elios4you" App  Menu
measurement to be assigned to the Energy Meter RC (Production/Transfer/Other)
For more information: www.4-noks.com/tutorial
11) Only if the Energy Meter RC is used to measure the power consumption of a load (Other mode): access the "Preferences"
section and check the box against "Show Smart Plug"

Check installation

If the connected Energy Meter RC has been installed in such a way as to replace one of the two sets of CTs, it is represented by the
next to the "Grid" icon or "Production" icon
Elios4you [Pro] Smart, the
If the Energy Meter RC is used to measure power transferred with a load, the measured value will be visible with an icon on the main screen
of the "Elios4you" App.
Check that the power reading is correct:
if used to read the power output from the photovoltaic source, compare the reading with that given by the inverter
9
if used to read power transfer with the grid, check that the direction of the current indicated is correct, and verify its difference
9
from 0.
if used to monitor the power usage of a load, switch on the load and check that the reading of the power it consumes is other than 0.
9

Operation

Switching on the main screen of the "Elios4you" App, it will be possible to view the measurement made by the Energy Meter RC device.
Note: in the absence of any radio signal between Energy Meter RC and Elios4you Smart, only the instantaneous production reading will be lost,
whereas the power reading (progressive) continues to register and will be visible as soon as the radio link is restored.
How to access the button
Fig. 1A: Remove the cover on the right hand part of the device
blinks at power-up (see table 1). If the Led comes on and remains permanently
 Smart RC  "Add Smart RC device"  "Start procedure" and select the type of
. Depending on the strength of the radio signal between the Energy Meter RC and the
icon can be
14
Button
Fig. 1B
icon