Eneo VMC-27LED Mode D'emploi page 34

4.3. HDMI (& DVI) Mode
Press the MENU button to display the HDMI menu. The follow setup menu will appears.
● HDMI menu
HDMI
Volume
Contrast
Brightness
Tint
Color
Sharpness
• Volume
Controls the output of the internal speakers.
• Contrast, Brightness
Change the contrast & brightness according to personal preference.
• Tint
Adjusts all the colors on the screen, but is most noticeable to the eye in reds and yellows,
And is also usually set for pleasing face tones. (Appears in NTSC mode only)
• Color
Used to minutely adjust color.
• Sharpness
Sets the desired sharpening enhancement to the picture.
● Advanced Menu
Advanced
Color Temp
Alarm
Energy Saving
3D NR
Anti Burn
Recall
Source
Panel scale
• Color Temp is used to control color temperature. (User, Normal, Warm, Cool)
• Alarm is input for the alarm level (Max 5Vdc) of sensor or any alarm device.
• 3D NR reduce the noise in the picture due to poor reception or poor picture quality.
(Off/Low/Middle/High)
• Anti Burn disable.
• Energy Saving change the Display Backlight. (OFF, Medium, Maximum) (27" only)
When decreasing the backlight, the brightness of the black becomes darker without any loss in
video signal and
the power consumption is reduced.
• Recall the monitor original factory setting.
• Source selects between the CVBS (Composite INPUT), S-Video (Super Video INPUT),
RGB (PC INPUT), DVR, DVI or HDMI to be displayed.
• Panel Scale
Change the scale. (4:3, Full)
Note: Not support HDCP (High-bandwidth Digital Content Protection) compliance.
>
>
< OFF >
MID >
< OFF >
>
< HDMI >
< Full >
14