Norco Trenton Instructions D'installation page 6

GB
1. Mounting of holding unit: Click the two nylon straps
on the handlebar. Shift nylon holding unit on the straps.
Tighten the four cross bolts (not too tight). Take care to
have the holder fi xed in slightly upward position.
2. Insert of nipples: Insert the two locking nipples inside
the holding unit. Mind correct position of cable holes.
3. Positioning of security cable: Feed cable from under
front structure of handlebar into the locking nipples in-
corporated at the backside of the holder. Pull both cable
ends downwards equally through the locking bushings.
4. Fixation of security cable: Fix cable on one side by
tightening the locking bolt. Pull the other end down-
wards fi rmly and tighten the bolt. Please take care to
have both keybolts fi rmly tightened (4 Nm).
5. Cable ends: Both ends are then to be bent to the middle
underneath the holder. (The cable may be replaced by
current type brake cable Ø 2-2.2 mm.)
6. Positioning of holding unit: Push holder downwards un-
til it is stopped by the cable. Then tighten the four black
screws in the holding unit (1 Nm). Please take care that
the unit is fi xed in a slightly upward position.
7. Using: Put the accessory on the adapter and push down-
wards until it locks automatically. Press red button to
release.
Important hint: Check secure mounting of the accessory
before each ride. If you transport the bike on the car, do not
leave the accessory in the adapter!
Maximum load of the adapter 7 kg.