Siemens LC97050/01 Notice De Montage page 10

Prior to installation
For optimum extractor hood efficiency:
Short, smooth air exhaust pipe.
As few bends in the pipe as possible.
Diameter of pipe to be as large as
possible and no tight bends in pipe.
If long, rough exhaust-air pipes,
many pipe bends or smaller pipe
diameters are used, the air extraction
rate will no longer be at an optimum
level and there will be an increase in
noise.
Round pipes:
We recommend
Internal diameter: 150 mm (at least
120 mm).
Flat ducts must have an internal cross-
section that equates to that of round
pipes.
There should be no sharp bends.
l 120 mm approx. 113 cm
l 150 mm approx. 177 cm
If pipes have different diameters:
Insert sealing strip.
For exhaust-air mode, ensure that
there is an adequate supply of fresh air.
Connecting a l 150 mm exhaust-air
pipe:
Mount the pipe directly onto the air
outlet on the hood.
Connecting a l 120 mm exhaust-air
pipe:
Place the reducing connecting piece
onto the air connecting piece – Fig. 3 –
and fasten the exhaust pipe to it.
Attach the exhaust-air pipe to the
reducing connector.
10
Circulating-air mode
circulating-air mode, you can purchase the
complete installation set at specialist
outlets.
Preparing the ceiling
2
Weight in kg:
2
LC91150
LC97050
LC95950
LC95150
LC92950
D8150N1
D8150N2
D91E1N0
We reserve the right to construction changes within the
context of technical development.
With activated carbon filter if exhaust-air
mode is not possible.
If the extractor hood is suitable for
The ceiling must be flat and horizontal.
Ensure that the ceiling is capable of
providing a firm hold for mounting
screws and plugs. The enclosed plugs
are suitable for concrete and stonework.
If the ceiling is made of any other
material, use appropriate mounting
components.
Exhaust
air
DIE975A 32
DIE995F 48
DIE945E 41
41
41
32
35
41
29
29
41
Fig. 4
Recircula-
ting air
34
50
43
43
43
34
37
43
31
31
43