Loading / Unloading The Nailer; Installing No-Mar Tip; Removing No-Mar Tip - Campbell Hausfeld CHN70700 Instructions D'utilisation

Operating Instructions and Parts Manual
Set-Up (Continued)

loadINg / uNloadINg tHe NaIler

Always disconnect the tool from the air supply before loading / unloading fasteners.
Choose which type of fastener you want to use for you project. Additional fasteners can
be found at major home centers.
loading the tool
1. Press down on latch and pull back on the magazine cover.
2. For nails, insert a stick of Campbell Hausfeld nails or equivalent (see "Fasteners"
section) into the magazine. Make sure the pointed ends of the fasteners are resting
on the bottom ledge of the magazine when loading. Make sure the nails are not dirty
or damaged.
3. For staples, load a clip of staples with the crowns straddling the magazine rail.
4. Push the magazine cover forward until the latch catches.
unloading the tool
1. Press down on latch and pull back on the magazine cover.
2. Remove fasteners.
3. Push the magazine cover forward until the latch catches.
adjuStINg tHe FaSteNer PeNetratIoN
The CHN70700 is equipped with an adjustable depth of drive feature. This allows the
user to determine how deep a fastener will be driven into the work surface.
1. Adjust the operating pressure to a pressure which will consistently drive the
fasteners. Do not exceed the maximum operating pressure of 100 psi.
2. To drive the fastener shallower, turn the wheel to left to the extent desired.
3. To sink a fastener deeper, turn the wheel to right to the extent desired.
4. Make sure trigger and work contact element (WCE) move freely up and down
without binding or sticking after each adjustment.

INStallINg No-Mar tIP

1. Disconnect air supply from tool.
2. Remove no-mar tip from the storage post.
3. Carefully place no-mar tip over the end of work contact element.
4. Check that the WCE and trigger move up and down freely without sticking or
binding.

reMovINg No-Mar tIP

1. Disconnect air supply from tool.
2. Pry no-mar tip away from the work contact element.
3. Replace no-mar tip onto the storage post for future use.
Figure 9 - loading the tool
Figure 10 - Fastener depth adjust
Figure 11 - No-mar tip
www.chpower.com
CHN70700
Storage
Post
No-mar Tip
11