Makita VC001GL Manuel D'instruction page 10

ASSEMBLY
CAUTION:
Always be sure that the appliance
is switched off and the battery cartridges are
removed before carrying out any work on the
appliance.
CAUTION:
Always wear dust mask during
assembly or maintenance.
Installing powder filter (HEPA) and
prefilter (for dry dust)
Optional accessory
CAUTION:
Never pick up water or other liq-
uids or wet dusts when using the powder filter.
Picking up such things may cause the powder filter
breakage.
To use powder filter:
1.
Loosen the screws securing the float cage, and
then remove the screws, float cage and float from the
head unit.
1
Fig.11
► 1. Screw 2. Float cage 3. Float 4. Head unit
2. Remove the cloth filter out of the tank.
1
2
Fig.12
► 1. Cloth filter 2. Tank
3. Place the prefilter into the tank aligning the mount-
ing position markings on the prefilter and tank.
4. Set the damper into the prefilter, and then place
the powder filter over the damper aligning the mounting
position markings on the powder filter and prefilter.
4
3
2
5. Mount the head unit over the tank and secure
them with the locking latches.
6
6
6
Fig.13
► 1. Head unit 2. Powder filter (HEPA) 3. Damper
4. Prefilter 5. Tank 6. Mounting position marking
NOTICE:
Before using the powder filter, make
sure that prefilter and damper are used together. It
is not allowed to install powder filter alone.
Installing water filter
Optional accessory
NOTICE:
Never pick up water or wet dust without
the float and the cloth filter or the water filter.
NOTICE:
For picking up wet dust, make sure that
the float cage and the float are installed on the
cleaner.
NOTICE:
When installing the water filter on the
tank, set it tight at the opening of the tank so
that the hook of the water filter engages the tank
opening firmly and there is no space between the
water filter and the tank.
10 ENGLISH
1
2
3
4
5