Adjusting The Volume; Setting The Sensitivity; Enabling Bass Amplification; Selecting A Station - SilverCrest SWDR 500 A1 Manuel D'utilisation Et Informations Sur Les Services

SilverCrest SWDR 500 A1
button to select your tuning region. Please remember that the date format is
also changed with this setting.

Adjusting the volume

Press the "VOL–" (12) and "VOL+" (4) buttons to adjust the volume to the
desired level. You can set it from level "00" (minimum volume) to level "16"
(maximum level). The device will always power on with the volume level that
was set when it was powered off.

Setting the sensitivity

This feature is only relevant for the FM and SW bands. Slide the
"DX/LOCAL" switch (22) to the "DX" position to use the device in normal
mode.
Slide the "DX/LOCAL" switch (22) to the "LOCAL" position to receive strong
broadcasting station signals only. This is recommended whenever a weaker
local station is receiving interference from a non-local station.

Enabling bass amplification

You can choose to have the bass sounds amplified.
 While the device is powered on, press the "SNOOZE/BASS" button (2).
BASS (31) is shown on the display (6).
 Press the "SNOOZE/BASS" button (2) again to disable bass amplification.
The "BASS" indicator (31) goes out.

Selecting a station

For an optimum reception, please fully extend the telescopic antenna (1)
before tuning a station. The telescopic antenna (1) can be rotated. This lets you
optimise the signal quality.

Automatic station search and automatic store

The most convenient way to search for and store radio stations is the automatic
scan with auto-store.
 Power the device on.
70 - English