Technical Information; Electrical Data - AEG PROSOURCE GYB00416ST Manuel D'installation Et Utilisation

42 www.aeg.com
Problem
Flow rate too high
Water drips from
the discharge pipe
of the pressure-
relief device

8. TECHNICAL INFORMATION

8.1 Important other technical information
• Refer to the separate manuals supplied with the other components for other
relevant technical information.
8.2 General data
Name
Ambient temperature
Humidity range
Maximum operation height
Protection grade

8.3 Electrical data

Connection
Voltage supply
Max. power consumption
Standby power loss (in ON position)
Standby power loss (in OFF position)
Cause
Too much pressure
Solution
• Close the valve of the
pressure safety valve (23)
or the cold water supply
valve.
• Place a pressure
reducing valve
• Do not do anything. This
is normal.
AEG ProSource
4~38 °C
25~85% relative humidity (RH)
2000 m
IPX4
4 litre
Earthed AC wall socket
230 V AC; 50 Hz
2200 W
15 W
0.4 W
8 litre
20 W
0.4 W