Introduction - AEG PROSOURCE GYB00416ST Manuel D'installation Et Utilisation

1. INTRODUCTION

1.1 Intended use and
unintended use
This AEG appliance is intended to be
used to store, heat and provide
drinking water. The appliance should
only be used in household and similar
environments, such as:
• In shops, offices and other similar
working environments;
• In farm houses;
• By clients in hotels, motels and other
residential type environments;
• In bed and breakfast type
environments.
The appliance should not be used:
• For commercial or industrial
purposes;
• In vehicles or on board ships or
aircrafts;
• In locations with the presence of a
corrosive or explosive atmosphere;
• For medical purposes;
The appliance may only be used
according to the instructions as
described in this manual. All use other
than described in this manual is seen as
unintended use.
1.2 General working
principle
This AEG appliance stores, heats and
provides boiling drinking water in
addition to cold and warm water.
To supply boiling water, cold water
flows from the cold water supply to the
boiler, where it is heated to 100 °C.
From the boiler the boiling water flows
to the tap.
The cold water also flows from the cold
water supply directly to the cold water
inlet on the tap.
There are two ways to provide the tap
with warm water:
– Warm water can be supplied by
connecting the warm water
supply, if available, to the warm
water inlet on the tap. This
situation is named the solo
configuration.
– Cold water and boiling water from
the boiler can be mixed with the
mixing valve. The mixed water
outlet of the mixing valve can be
connected to the warm water inlet
on the tap. This situation is named
the combi configuration.
ENGLISH 27