AEG PROSOURCE GYB00416ST Manuel D'installation Et Utilisation page 38

36 www.aeg.com
Step
8
9
10
Action
Connect the pressure safety valve.
If you are using a filter:
– Connect one end of the filter hose (40) to the t-piece (14) and the
other end to the water inlet of the filter (37) (see image 14).
– Connect one end of the cold water hose (26) to the water outlet of
the filter (41) and the other end to the cold water inlet of the
pressure safety valve (23) (see image 15).
If you do not use a filter:
– Connect one end of the cold water hose (26) to the t-piece (14)
and the other end to the cold water inlet of the pressure safety
valve (23) (see image 16).
Connect the boiler.
If you install the solo configuration:
– Connect the cold water inlet of the boiler (1) to the cold water
outlet of the pressure safety valve (18) (see image 17). NOTICE!
The cold water inlet of the boiler (1) bears a blue label.
If you install the combi configuration:
– Connect the cold water inlet of the boiler (1) to the cold water
outlet of the mixing valve (31) (see image 18). NOTICE! The cold
water inlet of the boiler (1) bears a blue label.
Connect the boiling water.
If you install the solo configuration:
– Connect the boiling water outlet of the boiler (2) to the boiling
water inlet of the tap (10) (see image 19). NOTICE! The boiling
water outlet of the boiler (2) bears a red label. The boiling water
inlet of the tap (10) bears a red label.
If you install the combi configuration:
– Connect the boiling water outlet of the boiler (2) to one end of the
extension hose (35). Connect the other end of the extension hose
(35) to the boiling water inlet of the mixing valve (27 or 28) (see
image 20). NOTICE! The boiling water outlet of the boiler (2) bears
a red label. The boiling water inlet) of the mixing valve (27 or 28) is
indicated with "H".
– Connect the boiling water inlet of the tap (10) to the boiling water
outlet of the mixing valve (27 or 28) (see image 21). NOTICE! The
boiling water inlet of the tap (10) bears a red label. The boiling
water outlet of the mixing valve (27 or 28) is indicated with "H".