Maintenance And Cleaning - Bellux BX5200 Mode D'emploi

fluids). Place the rubber nozzle in the opening of the hand-held
vacuum cleaner.
Switch the hand-held vacuum cleaner on and gently move it over
the fluid. Never vacuum fluid when the hand-held vacuum cleaner is
placed in the upright vacuum cleaner. This could cause serious damage
to the machine and the floor nozzle. After use, the hand-held vacuum
cleaner should be properly cleaned immediately.
This will prevent dirt from getting clogged in the opening.
▪
The crevice vacuum cleaner and the brush can only be used on dry
surfaces. The crevice vacuum cleaner can be used to vacuum dirt in
places that are hard to reach (e.g., a corner, a narrow opening, etc.).
The brush can be used to clean sofas, curtains or other types of textile.
Make sure that the plastic filter and the hepa filter are mounted
correctly.
▪ The upright vacuum cleaner may only be used on dry surfaces. When
you switch on the machine, the rotating floor brush at the bottom of
the floor nozzle will begin to turn. This will cause the dirt in the opening
to be shifted and thereby vacuumed up. The dirt will be collected in
the dust reservoir of the hand-held vacuum cleaner.
Make sure you do not vacuum large pieces of dirt, since they can
clog the nozzle opening. This could damage the machine. When
the battery is almost empty, the rotating floor brush will also stop
working.
When you turn on the machine (both the hand-held vacuum cleaner
and the upright vacuum cleaner), the indicator light on the hand-held
vacuum cleaner will go on for 1 second and immediately go out again.
This happens even when the power is switched off. If the indicator
light on the hand-held vacuum cleaner stays on, this means that the
machine will need to be charged soon. The suction power will be reduced and the battery will
empty slowly. Charge the machine as described in this manual.
To achieve the best results, you must clean the dust reservoir and the filter
after each use. This is better for the suction power and the life span of your machine. On this,
consult the section "Maintenance and cleaning".

MAINTENANCE AND CLEANING

CLEANING THE DUST RESERVOIR:
▪ Press the release button on the dust reservoir. Remove the dust reservoir of the motor
section (photo 9).
▪ Then remove the hepa filter and the plastic filter from the dust reservoir (photo 10).
▪
Empty the dust reservoir (photo 11).
46
All manuals and user guides at all-guides.com
BX5200