Setting Up The Device - TechniSat AUDIOMASTER MR3 Mode D'emploi

3 Setting up the device

> Place the device on a firm, secure and horizontal base. Make sure the area is well ventilated.
Caution!
> Do not place the radio on soft surfaces such as carpets and blankets or near to curtains and wall
hangings. These could obstruct the ventilation openings. The necessary flow of air could be interrupted
as a result. This could potentially lead to fire in the device.
> The ventilation slots at the rear and the sides must always be unobstructed. They must not be
obstructed by curtains, blankets or newspapers.
> Do not place the device near to sources of heat, such as radiators. Avoid direct sunlight and very dusty
environments.
> Do not select a location for the device with high air humidity, e.g. a kitchen or sauna, as the precipitation
of condensation water could damage the device. The device is intended for use in a dry environment
and in a moderate climate and must not be exposed to dripping or splashing water.
> Please note that the device footings could leave coloured marks on some types of furniture surfaces in
certain situations. Place a protective layer between your furniture and the device.
> You may only operate the device in a vertical position. Do not use outdoors!
> Do not place any heavy objects on the device.
> If you move the device from a cold environment to a hot environment, moisture could accumulate inside
the device. In such cases, wait approximately one hour before putting it into operation.
> Lay the mains cable in such a way that nobody can trip over it.
EN
FR
IT
NL
NW
DK
PL
CZ
SK
17