Technical Data; Declaration Of Conformity (Doc) - Renkforce 1285774 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Handling
• Only use in dry indoor locations. The product must not get damp or wet!
With the wall plug transformers there is also the deadly peril of an electric
shock!
• Never use the product immediately after it has been taken from a cold
room to a warm one. The condensation that forms might destroy your unit.
With the wall plug transformers there is also the deadly peril of an electric
shock!
Allow the product to reach room temperature, before connecting it to the
power supply and putting it in to use. This may take several hours.
• Any maintenance or repair work may only be performed by an authorised
repair shop.
• Check the product for damage before each use!
If you detect any damage, DO NOT connect the product to the mains supply!
A safe operation can no longer be assumed, if:
- the product shows visible signs of damage,
- the product does not function or does not function properly (e.g. a bur-
ning smell)
- the product was stored under unfavourable conditions
• When setting up the product, make sure that the cables are neither kinked
nor pinched.
• Avoid the following adverse conditions at the installation location and du-
ring transportation:
- Damp or excess air humidity
- Extreme cold or heat
- Dust or flammable gases, fumes or solvents
- Strong vibration
• If the product is not to be used for some time (e.g. during storage), unplug
the transmission stick and the receiver module from the power supply.
Unplug the wall plug transformer from the mains socket.
Declaration of Conformity (DOC)
We, Conrad Electronic SE, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare
that this product conforms to the fundamental requirements and the other relevant
regulations of the directive 1999/5/EC.
The Declaration of Conformity for this product can be found at
www.conrad.com.
Disposal
Dispose of an unserviceable product in accordance with the relevant statu-
tory regulations.
Technical data
a) Transmitter stick
Operating voltage............................... 5 V/DC
Supported resolutions ....................... 480p, 576p, 720p, 1080i, 1080p
Supported audio formats .................. max. 6Mbps AC3 and DTS
PCM 2 channel audio ........................ yes, 16/24bit, 32/44,1/48/96 kHz
3D transmission .................................. yes
Transmission frequency .................... 5 GHz
Transmission range ........................... max. 10 m
Latency ................................................ <1 ms
Dimensions.......................................... 83.2 x 30 x 17.1 mm (L x W x H)
Weight .................................................. 26 g
b) Receiver module
Operating voltage............................... 5 V/DC
Dimensions.......................................... 95 x 95 x 32 mm (L x W x H)
Weight .................................................. 115 g
c) Wall plug transformers (2 units)
Operating voltage............................... 100 - 240 V/AC, 50-60 Hz
Output................................................... 5 V/DC, 1.5 A
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2014 by Conrad Electronic SE.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

1285775

Table des Matières