Safety Message To Installers Of Federal Signal Products; Unpacking The Product; An Overview Of The Model 300Scw-1 - Federal Signal SelecTone 300SCW-1 Manuel D'installation Et D'entretien

Safety Message to Installers of Federal Signal Products

People's lives depend on your proper installation and servicing of Federal Signal products. It is important to
read and follow all instructions shipped with this product. In addition, listed below are some other important
safety instructions and precautions you should follow:
• This device is to be installed by a trained electrician who is thoroughly familiar with the National
Electric Code and will follow the NEC guidelines as well as local codes.
• Consult the authority having jurisdiction in your area regarding the proper use and installation of this product.
• The selection of the mounting location for the device, its controls and routing of the wiring is to be
accomplished under the direction of the Facilities Engineer and the Safety Engineer.
• Read and understand all instructions before installing or operating this equipment.
• Do not connect this unit to the system when power is on.
• Optimum sound distribution will be severely reduced if any objects are in front of the speaker. You
should ensure that the front of the speaker is clear of any obstructions.
• All effective warning speakers produce loud sounds which may cause, in certain situations, permanent
hearing loss. You should take appropriate precautions such as wearing hearing protection.
• All effective warning speakers produce loud sounds, which may cause, in certain situations, permanent
hearing loss. The device should be installed far enough away from potential listeners to limit their
exposure while still maintaining its effectiveness. The OSHA Code of Federal Regulations 1910.95
Noise Standard provides guidelines, which may be used regarding permissible noise exposure levels.
• After installation, test the sound system to ensure proper operation.
• Show these instructions to your Safety Engineer and all operating personnel, and then file them in a safe
place and refer to them when maintaining and/or reinstalling the unit.
• Establish a procedure to routinely check the sound system for proper activation and operation.
Failure to follow all safety precautions and instructions may result in property damage, serious injury, or death.

Unpacking the Product

After unpacking the product, examine it for damage that may have occurred in transit. If the 300SCW-1 has
been damaged, do not attempt to install or operate it. File a claim immediately with the carrier, stating the extent
of the damage. Disposal of all shipping materials must be carried out in accordance with national and local
codes and standards. Carefully check all envelopes, shipping labels, and tags before removing or discarding
them. If any parts are missing, please call Federal Signal Customer Support at 708-534-4756 or 877-289-3246.

An Overview of the Model 300SCW-1

The Model 300SCW-1 SelecTone® Command is a central control device that is capable of generating up
to four different tone signals on an audio line that is connected to remote speaker/amplifiers in a SelecTone
System. The 300SCW-1 can control signal lines to Federal Signal Models 300GC, 300GCX, 300X, 302GC,
302GCX, 302X, and 50GC speaker/amplifiers and to other devices. It can also operate with standard
Model 300SCW-1 Wall-Mounted Command Unit
Installation and Maintenance Manual
5