GE WSXH208 Manuel Du Propriétaire Et Instructions D'installation page 6

About the washer features.
CYCLE SIGNAL
O L
FF OUD
EXTRA RINSE
COTTONS / EASY CARE
O O
N FF
DOOR
LOCKED
6
NOTE: Not all features are available on all washer models.
Cycle Signal (on some models)
When the Cycle Signal is ON it will sound
at the end of the cycle. The signal can be
set at OFF (no sound), LOUD or anywhere
in between.
Extra Rinse
(available on some cycles)
Use an extra rinse when additional rinsing
is desired to remove excess dirt and
detergent from soiled loads.
Door Locked Indicator Light
The indicator light is ON and the door is
locked when the cycle knob is pulled out.
The light turns OFF at the end of the cycle.
AutoTemp (on some models)
AUTO TEMP senses the incoming water
temperature and adjusts the fill water to
obtain the correct wash temperature. This
feature is activated only when selecting a
COLD or WARM wash temperature.
For example, if a COLD wash is selected,
some warm water may be added to reach
a temperature needed to better dissolve
detergents. Often, detergents are not
completely dissolved in very cold water,
especially in cooler climates.