Connecting Inlet Hose - LG DLEY1201 Serie Mode D'emploi

Connecting inlet hose

The dryer must be connected to the cold water tap using the new water supply hose. Do not use old hoses
NOTE
• Water supply pressure must be between 21.8 PSI and 116 PSI (150~800 kPa).
• Do not strip or cross-thread when connecting inlet hose to the valve.
• If the water supply pressure is more than 800 kPa, a decompression device should be installed.
• Periodically check the condition of the hose and replace the hose if necessary.
• Replace inlet hoses after 5 years of use to reduce the risk of hose failure.
• Record hose installation or replacement dates on the hoses for future reference.
1. Check rubber seal in the inlet hose. Two rubber seals are
supplied with each inlet hose. They are used for preventing
water leaks. Make sure the connection to the cold water tap is
tight.
2. Check the installation type.
Short
hose
Y connector
WITH WASHER
Connect all water supply hoses tightly by hand and then
tighten another 2/3 turn with plier.
WITH WASHER: When connecting the dryer to the same faucet
as a washer.
a. Shut off the cold water tap and remove the washer hose.
b. Connect the short hose to the Y-conncetor using one of the
hose washers.
c. Connect the other end of the short hose to the cold water
faucet.
d. Connect the long dryer hose to one side of theY-connector and
connect the washer hose to the other side.
WITHOUT WASHER: If the dryer does not share the cold water
tap with a washer.
a. Connect the straight end of the long hose to the cold water faucet.
NOTE
• Before connecting the water line to the dryer, flush several
gallons of water into a drain or bucket. This will help prevent
foreign particles such as sand and scale from cloggong the
dryer inlet valve.
• Do not overtighten. Damage to the coupling can result.
Hose
connector
Rubber seal
Y connector
Long
hose
WITHOUT WASHER
INSTALLATION INSTRUCTIONS
3. Connect hose to dryer.
• Connect the water supply hose to the dryer inlet valve tightly by
hand and then tighten another 2/3 turn with plier.
Make sure that there are no kinks in the hoses and that they are
not crushed.
4. Turn on cold water faucet.
5. Check for leaks at the Y-connector (if used) and all hoses.
NOTE
• If any leaks are found, shut off the water faucet, remove the
hose and check the condition of the hose washer.
19