Belkin OmniView SMB Mode D'emploi page 43

Using the Remote IP Device
Auto Video Adjust
To adjust the video automatically:
1.
Open Internet Explorer (or similar) in the background.
2.
In the quick-access toolbar, click
3.
Select "Auto video adjust".
The process will take a few seconds. If the process runs for more than three
seconds, there may be an abnormal noise level. Check the video cable and verify
that no dynamic-video application is running on the target server's desktop.
Perform this procedure where necessary for each target server or new
screen resolution.
Fig. 18 Manual Video-Adjust Bar
.
1
2
3
4
5
6
7
8
9
UK-40